Oneida Air Systems Dust Cobra Owner's Manual page 19

Assembly Instructions (Continued)
Align the Nylon Elbow (F28) on the Cone (B)
14
with the Nylon Elbow (F29) on the Drum (D).
[FIG. 14] Attach the fully assembled unit onto
the Drum with Lid Clamp (D).
Note: Make sure that the Liner Bag (F41) is
smoothly laid over the edge of the Drum (i.e. no
folds or bunches) before fastening the drum shut
with the Drum Lid Clamp.
Install the Clear Vinyl Tubing (F36) onto the
15
Nylon Elbow (F28) on the Cone (B) with the
Nylon Elbow (F29) on the Drum (D). [FIG.
15]
Note: Push tubing onto elbows until the
connection is rm and tight.
If you did not purchase the Industrial Unit
(#IND), your installation is complete!
F28
F29
FIG. 14
F36
FIG. 15
oneida-air.com 17