Oneida Air Systems Dust Cobra Owner's Manual page 15

Assembly Instructions (Continued)
Secure both Handle Assemblies to pre-drilled
3
holes on sides of Drum (D) using Hex Head
Bolt (F2), Flat Washer, (F3), Rubber Washer
(F4), and Nylock Nut (F5) as shown in FIG 3.
Firmly Tighten.
Turn Cone Assembly (B) upside down and
4
install Strut (F7) using one Carriage Bolt (F9),
Rubber Washer (F10), two Flat Washers (F11),
and fasten with a Whiz-Lock Nut (F12) as
shown in FIG. 4.
Install umb Nut (F13) onto one of the Struts
(F7).
Note: is umb Nut (F13) will be used to
secure the Vacuum Hose Storage Strap (F15) to
the system.
Align the Cobra Gasket (F37) along the
5
bottom ange of the Cone Assembly (B).
Align the Drum Lid (E) with the Cobra Gasket
(F37), three Struts (F7), and Cone Assembly
holes as shown in FIG. 5a.
Note: e plugged hole (for the Dust Sentry
(M)) in the lid MUST be in the back. SEE FIG.
5b.
D
F6
Drum
F5 F1 F10 F11
FIG. 3
F9 F10 F11
B
F7
FIG. 4
FIG. 5a
oneida-air.com
F13
F12 F13
Back
Front
FIG. 5b
13