Assembly Instructions - Oneida Air Systems Dust Cobra Owner's Manual

Assembly Instructions

You will need the following tools:
GENER AL
Utility Knife
Phillips Head Screwdriver
5/16" Wrench
Place steel drum (D) on a at level surface
1
[FIG. 1].
If you purchased an Industrial (#IND) or
Vortex (#VOR) kit, install Drum Dolly (K) per
included instructions:
• Molded Drum Dolly Instructions
Note: Larger 3" Casters (N) are included with
#IND and #VOR Kits to replace the 2" Casters
packaged with the Drum Dolly (L).
Pull the le and right ends of the Webbing
2
Handle (F6) through loop 1 of the Handle
Plate (F1). en thread up through loop 2 and
into loop 3 [FIG. 2a]. Tuck the excess behind
the Handle Plate (F1) so that the end of the
Webbing Handle (F6) is captured between
the Drum (D) and the Handle Plate (F1). See
[FIG. 2b]
12 Oneida Air Systems
Two 7/16" Wrenches
1/2" Wrench
Adjustable Wrench
Tape Measure
Utility Knife
1
2
3
VORTEX
Pliers
FIG. 1
1
2
3
F1
FIG. 2a
F6
F1
FIG. 2b