Oneida Air Systems Super Dust Gorilla Owner's Manual
  1. Manuals
  2. Brands
  3. Oneida Air Systems Manuals
  4. Dust Collector
  5. Super Dust Gorilla
  6. Owner's manual

Oneida Air Systems Super Dust Gorilla Owner's Manual

Cyclonic dust collector
Hide thumbs Also See for Super Dust Gorilla:
Table of Contents

Advertisement

Quick Links

Download this manual
Cyclonic Dust Collector
Super Gorilla Owner's Manual
Oneida Air Systems, Inc. 1001 West Fayette St., Syracuse, NY 13204
Phone 1.800.732.4065 315.476.5151 Fax 315.476.5044 www.oneida-air.com
2hp 50 Hz
2hp 50 Hz
Shown with
optional Stand.
Models may vary slightly
in appearance.
6_10

Advertisement

Table of Contents
loading

Related Manuals for Oneida Air Systems Super Dust Gorilla

Summary of Contents for Oneida Air Systems Super Dust Gorilla

  • Page 1 2hp 50 Hz Cyclonic Dust Collector Super Gorilla Owner’s Manual 6_10 2hp 50 Hz Shown with optional Stand. Models may vary slightly in appearance. Oneida Air Systems, Inc. 1001 West Fayette St., Syracuse, NY 13204 Phone 1.800.732.4065 315.476.5151 Fax 315.476.5044 www.oneida-air.com...

  • Page 2: Table Of Contents

    Thank You for Choosing an Oneida Air Systems Product! OAS manufactures and sells dust collection equipment only. Our qualifi ed technicians and sales staff are available 7:30am - 6:00pm EST Mon. - Thurs. and 7:30am - 5:00pm EST Fri. to answer any questions concerning OAS products and dust collection.

  • Page 3: System Start-Up Information

    I. System Start-Up Information 1. Read the installation and maintenance instructions as well as the recommended safety practices in this manual 2. Install ductwork completely before operating collector: A.) Seal ductwork with silicone sealant or duct tape. B.) Have dust bin in place and sealed. 3.
  • Page 4 II. Super Dust Gorilla Confi gurations Caution: If exhaust air is vented outside you must provide make up / return air. Flue gases (carbon monoxide) can be drawn into the shop from furnaces, water heaters or other appliances. 1. External Cartridge Filter - Silencer Included with Filter Cartridge Filter Media 99cm / 8.83 Sq.

  • Page 5: General Specifi Cations & Fan Performance Curve

    III. General Specifi cations & Fan Performance Curves 2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010...

  • Page 6: Dimensions

    IV. Dimensions For Minimum Mounting Heights w/ 99 cm Filter *Dimensions subject to slight variation in manufacturing. 123 cm 61.6 cm 67.5 cm 33 cm Allow 2.5 - 5 cm from ceiling 20.3 cm 2 & 2.5hp - 231.1 cm 92.00”...

  • Page 7: General Assembly

    V. General Assembly 1. Motor Assembly - (2hp) BXI002105 / (2.5hp) BXI002505 1a. 2hp motor - BMZ020105 / 2.5hp - BMZ025105 (8) 5/16” Clips (8) 5/16” Bolts 4. Cyclone Cone - SCX002105 / SCX025105 5a. Plenum - FPX000001 5b. J - Hooks (8) - AFJ051602 / AFT000001 (8) 5/16”...
  • Page 8 VI. Assembly Instructions Instructions for assembly of the Fan Blower Housing and Barrel of the Oneida Models. 1. Push clips onto inside circle on Fan Housing, making sure clip is pushed all of the way on, that the bolt holes are in alignment with the clip holes and that the small barrel on the clip is on the INSIDE of the Fan Housing as shown in diagram.

  • Page 9: General Assembly Instructions

    VI. General Assembly Instructions Do NOT use hook on motor to lift unit. There are essentially three ways to assemble your collector and to at- tach it to the stand. The way that is right for you should be determined by expertise and manpower available.
  • Page 10 2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010...

  • Page 11: Filter Assembly

    VIII. Filter Assembly 2hp Filter Plate 4 hole side is near External 99 cm Filter Assembly dust collector. Gasket *Silencer Included 1. Attach gasket to collector outlet making sure there are no gaps where gasket ends meet. 2. Attach Plenum to outler using the included 7 bolts and hardware making sure the support hanger on the Plenum is at the bottom.

  • Page 12: Filter Maintenance

    IX. Filter Maintenance External Filter Cartridge Cleaning Intervals When unit is turned off, use compressed air to blow dust off from exterior of fi lter. Hold nozzle at least 6” away from fi lter pleats*. Do not remove bottom dust pan before or during the blow-off process! Let dust settle into dust pan.
  • Page 13 X. Directions for Cleaning External Filter All steps should be done with a dust mask and eye protection. Proper fi lter clean- ing should not be neglected. A dirty fi lter can affect dust collector operation and fi lter life. 1.
  • Page 14 XI. Wiring Diagram for Magnetic Starter (220v, 1 **)* SFA = 12.1 (FLA = 11.5) *Starter will not operate at any other voltages. *Starter is shown confi gured for 1O. 2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010...

  • Page 15: Troubleshooting

    Motor Overheating with your collector, call The motor’s internal circuit breaker will trip if the motor is overheating. Oneida Air Systems at Motor amperage too high - Shut system down. 1.800.732.4065 for assis- tance. Caused By: System should be completely bolted and sealed together.

  • Page 16: Fire Hazards

    XIII. Fire Hazards - Read Before Installing and Operating Oneida Collectors are designed for WOOD DUST only!! Wood shaping and cutting processes generate wood chips, shavings, and dust. These materials are considered combustible. Air borne wood dust below 420 microns in size (,017 of an inch) in certain concentration ranges when ignited can defl agrate (burn quickly). An ignition source such as a spark or ember can ignite a dust mixture resulting in an expanding fl...

  • Page 17: Terms And Conditions

    Limited Warranty Oneida Air Systems warrants products it manufactures for a period of 2 years to the original purchaser from the date of purchase. Items not manufactured by O.A.S. are limited to their own manufacturer’s warranties. All electrical items such as magnetic starters, remotes, sensors, pumps and sccessories are limited to 90 days.

  • Page 18: Stand Assembly

    XV. Stand Assembly 35 & 55 Gal. Stand - STG000035 / STG000055 Top Gusset Stand Kit Contents Stand Brace Hardware Kit (1) - AHX000100 Mid - Gusset 56”/ 68” Rubber Leg Cap (4) - RCR012500 Top Gusset (4) - RFG010000 Rubber Leg Cap 27.5”...

  • Page 19: Accessories

    XVI. Accessories Bolt Together Stand STG000035 - 35 Gal. Stand STG000055 - 55 Gal. Stand Replacement Filter FCS133900 (2hp) / FCS183900 (2.5hp) 13”x 39” / 95 Sq. Ft. Spun-Bonded. Filters 99.9% of test material from 0.2 - 2 microns. 18”x 39” / 110 Sq. Ft. Spun-Bonded. Filters 99.9% of test material from 0.2 - 2 microns.

  • Page 20: Fan Motor Maintenance

    XVII. Fan Motor Maintenance Per Baldor specifi cations, their 2 pole motors (3600 RPM) motors are to be relubricated every 5500 hours. 2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010...

  • Page 21: Optional Remote Controller Diagram

    XVIII. Optional Remote Controller Diagram Applies If You Have the Remote Controller Type: MS1 MS1-XXD 1 (3) X7 NXX XP-RW Voltage: AC100 - 120v / 50-60 Hz and AC220 - 240v / 50-60 Hz (or appoint other voltage) Frequency: 303.9 MHz Temperature: -5 C to 60 C Action Mode: ON Blue - Motor Start / OFF Red - Motor Stop Remote Controller Diagram...

Table of Contents