Oneida Air Systems Dust Cobra Owner's Manual page 16

Assembly Instructions (Continued)
Secure the Cone Assembly (B) to the Drum
6
Lid (E) with a Hex Bolt (F38), two Flat
Washers (F39), and a Whiz-Lock Nut (F37) as
shown in FIG. 6.
Secure the Strut (G3) to the Drum Lid (E)
with a Hex Bolt (F8), two Flat Washers (F11),
a Rubber Washer (F10) and a Whiz-Lock Nut
(F12) as shown in FIG. 6.
Turn Cone Assembly (B) right side up and
7
secure Nylon Elbow (F28) into upper drilled
hole with Rubber O Ring (F33), Nylon Washer
(F32), and the Nut included on the Nylon
Elbow (F28) [FIG. 7a].
Install Bag Hold Down Kit into pre drilled
hole located on the Drum (D) [FIG. 7b].
• Refer to the Quick Disconnect Installation
Sheet (#ZBI000019) for more information.
14 Oneida Air Systems
B
FIG. 6
F38
F39
F37
F39
F37
FIG. 6
F28 F33 F32
FIG. 7a
F29 F30
FIG. 7b
F8
F7
F11
E
F10
F11
F12
F28
B
F31 F32 F34
F33