Oneida Air Systems Dust Cobra Owner's Manual page 22

Vortex Assembly Instructions (Continued)
Attach the Clear Cone Assembly (S3) to the
23
bottom of the Vortex Barrel (S2) and use the 8"
Quick-Clamp (S4E) to secure them together.
[FIG. 23]
Remove cardboard ring from the Rubber
24
Coupling (S4F); you may need pliers to do so
[FIG. 24a].
Remove the pre-installed clamps from the
Rubber Coupling (S4F) [FIG. 24b]. Install
the Rubber Coupling narrow end down, onto
the dust pipe of your oor sander or onto
the purchased handle.
Coupling should be level with the top of the
dust pipe. Secure it in place using one of the
Rubber Coupling Hose Clamps (S4F).
Secure the inlet of the Vortex Barrel (S2)
25
onto the dust pipe of your oor sander or
purchased handle by sliding the open end of
the Vortex Barrel Inlet Elbow in between the
dust pipe or your purchased handle and the
Rubber Coupling (R4F). Make sure the slot in
the side of the inlet elbow is covered entirely
by the rubber coupling.
e rubber coupler should then be sealed in
place using the Rubber Coupling Band Clamp
(R4G) on the Rubber Coupler. [FIG. 25]
20 Oneida Air Systems
e top of the Rubber
FIG. 23
FIG. 24a
FIG. 24b
FIG. 25
FIG. 24c
R2
R4F
Dust pipe or
Purchased Handle