Oneida Air Systems Dust Cobra Owner's Manual page 17

Assembly Instructions (Continued)
Install Gasket (F27) around the top outer rim
8
of the Cone Assembly (B) [FIG 8.]
Note: Align the gasket notches over the notches
in the rim. Dust collection systems cannot
operate e ectively if there isn't a complete seal.
ere must be NO air leaks.
Secure Draw Latches (F24) to Cone Assembly
9
(B) with Pan Head Screws (F25) and Nylock
Nuts (F26). [FIG 9.]
Screw two Whiz-Lock Nuts (F17) up the sha
10
of two J Bolts (F16).
onto the motor plate with the J Bolts (F16)
pointing out as shown in FIG. 10a.
Note: When properly installed, the distance
between the motor plate and the top of the
5/16"-18" x 2" J bolt is 1-11/16". [FIG 10b]
Install Filter Retainer Strap (F18) onto the J
Bolts (F16) [FIG 10c]
Note: If your lter retainer strap has steel
S-hooks on the ends, remove and discard.
are not needed for the install.
en screw J Bolts (F16)
ey
Notches
Front (Top View)
F24 F26
F25
FIG. 9
FIG. 10a
FIG. 10c
FIG. 8
F16
F17
FIG. 10b
F18
oneida-air.com
F27
1
11/16"
15