Table of Contents
Advertisement
5.8
Parameter clear / All parameter clear
• Set "1" to Pr.CLR Parameter clear or ALL.CL All parameter clear to initialize all parameters. (Parameters cannot be cleared
when Pr.77 Parameter write selection = "1".)
• Terminal function selection parameters are not cleared even after Parameter clear has been performed.
• Refer to the parameter list on
Operating procedure
1.
Turning ON the power of the converter unit
The operation panel is in the monitor mode.
2.
Selecting the parameter setting mode
Press
to choose the parameter setting mode. (The parameter number read previously appears.)
3.
Selecting a parameter number
Turn
to "
. "
(initial value)" appears.
4.
Parameter clear
Turn
to change the set value to "
("
• Turn
to read another parameter.
• Press
to show the setting again.
• Press
twice to show the next parameter.
Setting
0
Initial display (Parameters are not cleared.)
The settings of parameters except for terminal function
1
selection parameters are initialized.
page 172
for parameters cleared with this operation.
" for Parameter clear or turn it to "
". Press
") are displayed alternately after parameters are cleared.
Pr.CL Parameter clear
" for All parameter clear, and press
to enter the setting. "
Description
ALL.C All parameter clear
The settings of all the parameters, including terminal function
selection parameters, are initialized.
5.8 Parameter clear / All parameter clear
" and "
"
131
5. PARAMETERS
1
2
3
4
5
6
7
8
9
10
Advertisement
Table of Contents
