Chapter 4 Basic Operation; Operation Panel; Components Of The Operation Panel - Mitsubishi Electric FR-CC2-N Series Instruction Manual

4
BASIC OPERATION
4.1

Operation panel

This chapter explains the basic operation of this product.
Always read the instructions before use.
4.1.1

Components of the operation panel

Install the operation panel of the inverter on the converter unit.
To mount the operation panel on the enclosure surface, refer to
No. Appearance
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
62
4. BASIC OPERATION
4.1 Operation panel
(j)
(k)
(l)
(m)
Name
— Not available for the converter unit.
MON: ON when the operation panel is in the monitor mode. Quickly blinks twice
Operation panel mode intermittently while the protective function is activated.
LED indicator Slowly blinks when the display-off function of the operation panel is valid.
PRM: ON when the operation panel is in the parameter setting mode.
— Not available for the converter unit.
— Not available for the converter unit.
Shows a numeric value (readout) of a monitor item such as the frequency or a parameter
number.
Monitor (5-digit LED)
(The monitor item on each screen can be changed according to the settings of Pr.774
to Pr.776.)
— Not available for the converter unit.
— Not available for the converter unit.
STOP/RESET key Used to reset the converter unit when the protective function is activated.
Turn the setting dial to change the parameter settings.
Press the setting dial to perform the following operations:
Setting dial
• To display a monitor item set in Pr.992.
• To display a fault record number in the fault history mode.
Switches the operation panel to a different mode.
Every key on the operation panel becomes inoperable by holding this key for 2 seconds.
MODE key
The key inoperable function is invalid when Pr.161 = "0 (initial setting)". (Refer to
77.)
page 49.
(a) (b) (c)
Description
(d)
(e)
(f)
(g)
(h)
(i)
page