Mitsubishi Electric FR-CC2-N Series Instruction Manual page 7

Electric shock prevention
WARNING
 Do not remove the front cover or the main circuit terminal cover while the power of this product is ON, and do not run
this product with the front cover or the main circuit terminal cover removed as the exposed high voltage terminals or the
charging part of the circuitry can be touched. Otherwise you may get an electric shock.
 Even if power is OFF, do not remove the front cover or the main circuit terminal cover except for wiring or periodic
inspection as the inside of this product is charged. Doing so may cause an electric shock.
 Before wiring or inspection, check that the LED display of the operation panel is OFF. Any person who is involved in
wiring or inspection shall wait for 10 minutes or longer after the power supply has been cut off, and check that there are
no residual voltage using a digital multimeter or the like. The capacitor is charged with high voltage for some time after
power OFF, and it is dangerous.
 Be sure to earth (ground) the inverter. Earthing (grounding) must conform to the requirements of national and local safety
regulations and electrical code (NEC section 250, IEC 61140 class 1 and other applicable standards).
 Any person who is involved in wiring or inspection of this product shall be fully competent to do the work.
 This product body must be installed before wiring. Otherwise you may get an electric shock or be injured.
 Do not touch the setting dial or keys with wed hands. Doing so may cause an electric shock.
 Do not subject the cables to scratches, excessive stress, heavy loads or pinching. Doing so may cause an electric shock.
 Do not change the cooling fan while power is ON as it is dangerous.
 Do not touch the printed circuit board or handle the cables with wet hands. Doing so may cause an electric shock.
Fire prevention
CAUTION
 This product must be installed on a nonflammable wall without holes in it so that its components cannot be touched from
behind. Installing it on or near flammable material may cause a fire.
 If this product becomes faulty, the product power must be switched OFF. A continuous flow of large current may cause
a fire.
 Be sure to perform daily and periodic inspections as specified in the Instruction Manual. There is a possibility of
explosion, damage, or fire if this product is used without inspection.
Injury prevention
CAUTION
 The voltage applied to each terminal must be as specified in the Instruction Manual. Otherwise an explosion or damage
may occur.
 The cables must be connected to the correct terminals. Otherwise an explosion or damage may occur.
 The polarity (+ and -) must be correct. Otherwise an explosion or damage may occur.
 While power is ON or for some time after power-OFF, do not touch this product as it will be extremely hot. Doing so may
cause burns.
Additional instructions
The following instructions must be also followed. If this product is handled incorrectly, it may cause unexpected fault, an injury,
or an electric shock.
6