Table of Contents
Advertisement
Copying parameter settings stored in the operation panel to the
converter unit
Operating procedure
1.
Connect the operation panel to the destination converter unit.
2.
Selecting the parameter setting mode
Press
to choose the parameter setting mode. (The parameter number read previously appears.)
3.
Selecting the parameter number
Turn
to "
"
" appears.
4.
Selecting parameter write
Turn
to change the set value to "
appears.
5.
Writing to the converter unit
Press
to start writing the parameter settings stored in the operation panel to the converter unit. (It takes about
60 seconds to write all the settings. During copying, "
6.
End of copying
"
" and "
7.
When parameters are written to the destination converter unit, reset the converter unit before operation by, for
example, turning the power supply OFF.
NOTE
• "
" appears when a parameter write error occurred. Perform the operation from step 3 again.
" (Parameter copy), and press
", then press
" are displayed alternately after copying ends.
.
.
" blinks.)
5.9 Parameter copy and parameter verification
1
2
3
4
5
6
7
8
9
10
133
5. PARAMETERS
Advertisement
Table of Contents
