Mitsubishi Electric FR-CC2-N Series Instruction Manual page 22

(c) With the lower cover removed, loosen the mounting screws on the upper cover. (These screws cannot be removed.)
(d) Pull out the upper cover using its upper side as a support.
(e) With the upper cover removed, the control circuit and the RS-485 terminals can be wired.
 Reinstallation of the front cover
(a)
(a) Insert the upper hooks of the upper front cover into the sockets of the converter.
Check that it is properly secured.
(b) Tighten the screws on the lower part of the cover.
(c) Attach the lower front cover using the screws.
NOTE
• Fully make sure that the front cover has been reinstalled securely. Always tighten the installation screws of the front cover.
(b)
Tighten Tighten Tighten
(c)
Tighten Tighten Tighten
2. INSTALLATION AND WIRING
2.2 Removal and reinstallation of the cover
1
2
3
4
5
6
7
8
9
10
21