Table of Contents
Advertisement
1.
Strip the signal wires as shown below. If too much of the wire is stripped, a short circuit may occur with neighboring
wires. If not enough of the wire is stripped, wires may become loose and fall out.
Twist the stripped end of wires to prevent them from fraying. Do not solder it.
Wire strip length
2.
Crimp the terminals on the wire.
Insert wires to the crimp terminal, and check that the wires come out for about 0 to 0.5 mm from a sleeve.
Check the condition of the crimp terminals after crimping. Do not use the crimp terminals of which the crimping is
inappropriate, or the face is damaged.
Crimp terminals commercially available (as of January 2017)
• Phoenix Contact Co., Ltd.
Wire gauge
2
(mm
)
With insulation sleeve
0.3
AI 0,34-10TQ
0.5
AI 0,5-10WH
0.75
AI 0,75-10GY
1
AI 1-10RD
1.25, 1.5
AI 1, 5-10BK
0.75 (two-wire
AI-TWIN 2×0,75-10GY
product)
*1
A ferrule terminal with an insulation sleeve compatible with the MTW wire which has a thick wire insulation.
*2
Applicable for terminals A1, B1, C1.
• NICHIFU Co., Ltd.
Wire gauge
Blade terminal part
2
(mm
)
0.3 to 0.75
BT 0.75-11
3.
Insert the wires into a socket.
Damaged
Ferrule part No.
Without insulation
sleeve
—
—
A 0,75-10
A 1-10
A 1, 5-10
—
Insulation cap part No.
No.
VC 0.75
Crumpled tip
Crimping tool
*1
model No.
For UL wire
—
AI 0,5-10WH-GB
AI 0,75-10GY-GB
AI 1-10RD/1000GB
CRIMPFOX 6
*2
AI 1,5-10BK/1000GB
—
Crimping tool product
number
NH 69
When using single wire or stranded wire without crimp
terminal, push an open/close button all the way down with a
flathead screw driver, and insert the wire.
Unstranded
wires
Wires are not inserted
into the sleeve
Open/close button
Flathead screwdriver
2. INSTALLATION AND WIRING
2.6 Control circuit
1
2
3
4
5
6
7
8
9
10
43
Advertisement
Table of Contents
