Mitsubishi Electric FR-CC2-N Series Instruction Manual page 8

CAUTION
Transportation and installation
 To prevent injury, wear cut-resistant gloves when opening packaging with sharp tools.
 Use proper lifting techniques or a trolley when carrying products. Failure to do so may lead to injuries.
 Do not stand or place any heavy object on this product.
 Do not stack the boxes containing this product higher than the number recommended.
 When carrying this product, do not hold it by the front covers or the main circuit terminal covers. It may fall or break.
 During installation, caution must be taken not to drop this product as doing so may cause injuries.
 This product must be installed on a surface that withstands the weight of the product.
 Do not install this product on a hot surface.
 Ensure the mounting orientation of this product is correct.
 Ensure this product is mounted securely in its enclosure.
 Do not install or operate this product if it is damaged or has parts missing.
 Foreign conductive objects must be prevented from entering this product. That includes screws and metal fragments or
other flammable substance such as oil.
 As this product is a precision instrument, do not drop or subject it to impact.
 The surrounding air temperature must be between -10°C and +40°C (non-freezing). Otherwise this product may be
damaged.
 The ambient humidity must be 95% RH or less (non-condensing) for this product. Otherwise this product may be
damaged. (Refer to page 22
 The temporary storage temperature (applicable to a short limited time such as a transportation time) must be between -
20°C and +65°C. Otherwise this product may be damaged.
 This product must be used indoors (without corrosive gas, flammable gas, oil mist, dust and dirt). Otherwise this product
may be damaged.
 This product must not be used at an altitude above 4000 m. The maximum amplitude amount must be 0.075 mm
(frequency range: 10 to 57 Hz), and the maximum acceleration speed must be 1G (frequency range: 57 to 150 Hz).
Otherwise this product may be damaged. (Refer to
 If halogens (including fluorine, chlorine, bromine, and iodine) contained in fumigants for wood packages enter this
product, the product may be damaged. Prevent the entry of fumigant residuals or use an alternative method such as heat
disinfection. Note that sterilization of disinfection of wood packages should be performed before packing the product.
Test operation
 Before starting the test operation, confirm or adjust the parameter settings. Failure to do so may cause some machines
to make unexpected motions.
WARNING
Usage
 Stay away from the equipment after using the retry function in this product as the equipment will restart suddenly after
the output shutoff of this product.
 Depending on the function settings of this product, the product does not stop its output even when the STOP/RESET
key on the operation panel is pressed. To prepare for it, provide a separate circuit and switch (to turn OFF the power of
this product, or apply a mechanical brake, etc.) for an emergency stop.
 Be sure to turn OFF the start (STF/STR) signal before clearing the fault as this product will restart the motor suddenly
after a fault is cleared.
 Do not modify this product.
 Do not remove any part which is not instructed to be removed in the Instruction Manuals. Doing so may lead to a failure
or damage of this product.
for details.)
page 22 for details.)
7