Local Diagnostics Test - Visonic KF-234 PG2 Accessories Manual

NEXT CAM PG2, NEXT-K9 CAM PG2
30.
Normal
or
31.
32.
IMAGE CONTRAST
33.
MIC. SETTINGS
34.
Enable
35. or
36.
MIC. SETTINGS

5. LOCAL DIAGNOSTICS TEST

A. Separate the base from the cover (see Fig. 5).
B. Put back the cover to return the tamper switch to its normal (undisturbed) position, and then secure the front
cover to the base with the case closure screw.
C. Walk-test the coverage area - see fig. 2. Walk across the far end of coverage pattern in both directions, The
red LED lights each time your motion is detected followed by 3 LED blinks.
The following table indicates received signal strength indication.
IMPORTANT!
reception must be assured.
Therefore,
strength is not acceptable. If
you receive a "poor" signal
from the detector, re-locate it
and re-test until a "good" or
"strong"
received.
Note: For detailed Diagnostics
Test
PowerMaster-10 Installer Guide.
16
Select between "-3", "-2", "-1", "Normal", "+1", "+2" and "+3".
Here you determine whether or not to activate the microphone.
Select between "Enable" and "Disable".
When exiting "
displays the number of devices that need to be updated, as follows: DEV
UPDATING NNN.
For detailed instructions on Adding Devices, Deleting Devices, Replacing
Devices and Defining Defaults see the PowerMaster-10 Installer Guide.
LED response
Green LED blinks
Orange LED blinks
Red LED blinks
No blinks
Reliable
"poor" signal
signal strength is
instructions refer to
" menu, the PowerMaster-10 system
ZONES / DEVICES
Reception
Strong
Good
Poor
No communication
ENROLL
button
Figure 3. Device enroll button
D-302758