Repeaters (Rp-610; Introduction; Specifications; Installation - Visonic KF-234 PG2 Accessories Manual

REPEATERS (RP-610 PG2)
Wireless Repeater for PowerG Communications

1. INTRODUCTION

The RP-610 PG2 is a range extender designed to relay digital data
between wireless PowerMaster-10 Devices and a PowerMaster-10
Control Panel. Repeater links are required when the Control Panel is
beyond the range of at least some of the devices and is therefore
incapable of receiving transmissions directly (see Figure 3).

2. SPECIFICATIONS

Frequency Band (MHz)
Modulation
Antenna
Communication Protocol
AC Power Supply
Backup Battery
Nominal Current Drain
Battery Backup Duration (with
fully charged 1300 mA/h
battery)
LED indicator
Operating Temperature
Dimensions
Weight
Compliance with Standards

3. INSTALLATION

3.1 Repeater's Location Selection

A. In a repeater setup, install the repeater where good communication is assured with the target receiver and with the
transmitters deployed in the repeater's coverage area.
B. Mount the repeater as high as possible above the floor and well away from metal chimneys, large metal
cabinets, metal doors and reinforced concrete walls, all of which may reduce the communication range.
C. Make sure that the location you have selected is near an electrical outlet.
D-302758
Europe: 433, 868, USA: 915
GFSK
Built-in antenna
PowerG
AC to AC adaptor:
120 VAC, 60 Hz / 9 VAC, 0.35 A min. (in the U.S.A.)
230 VAC, 50 Hz / 9 VAC, 0.35 A min.
4.8-Volt 1300 mAh NiMH rechargeable.
Caution!
Risk of explosion if battery is replaced by an incorrect type. Dispose of
used battery according to manufacturer's instructions.
Frequency (MHz)
48 hours.
Green LED lights when AC power on.
0°C to 49°C (32°F to 120°F).
161x161x50mm (6-7/16 x 6-7/16 x 1-3/4 in)
470g (16.5 oz.)
Europe: EN 50131-1, EN 50130-5, EN 50131-6, EN 301489, EN 50130-4,
EN 300 220
USA: (FCC) CFR47 Part 15
Canada: RSS210
RP-610 PG2
Figure 1: External View
433 868
100 mA 100 mA
915
100 mA
35