Cover Closure; Notes And Warnings; Product Limitations; Compliance With Standards - Visonic KF-234 PG2 Accessories Manual

RP-610 PG2

8. COVER CLOSURE

See figure 5.

9. NOTES AND WARNINGS

9.1 Product Limitations

Visonic Ltd. wireless systems are very reliable and are tested to high standards. However, due to their low
transmitting power and limited range (required by FCC and other regulatory authorities), there are some
limitations to be considered:
A. Receivers may be blocked by radio signals occurring on or near their operating frequencies, regardless of
the code selected.
B. Wireless equipment should be tested regularly to determine whether there are sources of interference and to
protect against faults.

9.2 Compliance with Standards

Interference Prevention
This device complies with FCC Rules Part 15. Operation is subject to two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference that may be received or that may
cause undesired operation.
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The digital circuitry of this device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in residential installations. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio and television reception. However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause such interference, which can be verified by turning the device off
and on, the user is encouraged to eliminate the interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
This device complies with the essential requirements and provisions of Directive 1999/5/EC of the European
Parliament and of the Council of 9 March 1999 on radio and telecommunications terminal equipment.
38
1
2
Figure 5 -
Cover Closure
D-302758