Modify Device Settings - Visonic KF-234 PG2 Accessories Manual

SMD-426, SMD-427

5. MODIFY DEVICE SETTINGS

This section describes how to configure the parameters of the smoke detector from the PowerMaster-10 control
panel.
To Modify the Smoke Detector Device Settings
Refer to the PowerMaster-10 Installer Guide and perform the procedure for Adding A Wireless Device (section
4.5.2), or, Modifying a Device (section 4.5.5). Then continue below to modify the device settings.
DEV SETTINGS
1.
Burglary Siren
2.
enable
or
3.
4.
Burglary Siren
5.
Fire Siren
6.
enable
7. or
8.
Fire Siren
9.
Gas / CO Siren
10.
enable
or
11.
12.
Gas / CO Siren
13.
Flood Siren
14.
enable
15. or
16.
Flood Siren
26
Here you determine whether or not the detector will activate a burglary
alarm.
Select between "enable" and "disable".
Here you determine whether or not the detector will activate a fire alarm.
Select between "enable" and "disable".
Here you determine whether or not the detector will activate a gas alarm.
Select between "enable" and "disable".
Here you determine whether or not the detector will activate a flood alarm.
Select between "enable" and "disable".
When exiting "
ZONES / DEVICES
displays the number of devices that need to be updated, as follows: DEV
UPDATING NNN.
For detailed instructions on Adding Devices, Deleting Devices, Replacing
Devices and Defining Defaults see the PowerMaster-10 Installer Guide.
" menu, the PowerMaster-10 system
D-302758