Sirens (Sr-730; Introduction - Visonic KF-234 PG2 Accessories Manual

SIRENS (SR-730 PG2)
Fully Wireless PowerG Outdoor Siren

1. INTRODUCTION

The SR-730 PG2 is a fully wireless outdoor siren, designed for installation in areas in which wiring action is
difficult or impossible.
The siren is compatible with PowerMaster-10 control panels.
Features
• Siren and strobe light activation: When an identified event message is received from the compatible
PowerMaster-10 alarm system, the siren activates its sounder & strobe light.
Notes:
The sounder is activated for a predefined "Bell Time" (refer to PowerMaster-10 Installer Guide, par. 4.3),
according to local authorities requirements, or until the system is disarmed, whichever occurs first.
The strobe light operates as described in the PowerMaster-10 Installer Guide, par. 4.3.
• Tamper indication: In case of tamper while the system is armed, the siren transmits the message to the
alarm system and then the alarm system determines whether the siren should be activated or not. If the siren
does not receive an acknowledge message from the alarm system, the siren will function independently.
• Low battery voltage alert
When the battery voltage is low, a low battery message is sent to the alarm system. After the low voltage
message delivery, at least 2 siren alarms are possible before the siren is totally inactive.
• Power Supply Options: Non-rechargeable battery. Optional - two non-rechargeable batteries.
• Sound Types: Burglar (between 1400Hz - 3200Hz), fire, gas/Co and flood.
• Entry/Exit: Exit delay beeps sound once the user has armed the system. Entry delay beeps sound once the
user has entered the protected area. (Entry/exit beeps can be enabled / disabled from the PowerMaster-10
Installer menu.)
• Squawk indications: Squawk (beep) sounds can be used to indicate alarm system arming (1 squawk) and
disarming (2 squawks) by a keyfob (squawk can be enabled from the PowerMaster-10 User menu).
• Strobe Light Color: The siren can be purchased with red, blue, amber or transparent lens, according to the
desired strobe light color.
• Siren activity LED: A flashing LED (optional, at the bottom of the siren front panel) indicates siren activity
(can be disabled by the control panel)
• Double Tamper protection: When the siren front panel is removed or when the siren is removed from the
wall, tamper alarm is sent to the alarm system.
IMPORTANT! The SR-730 PG2 siren must be
installed on the wall in a vertical position with the
screw pointing to the floor only, as illustrated in
Figure 1b. The importance of correct positioning of
the SR-730 PG2 is to enable the siren to function as
a waterproof device.
• 2-way full supervision
The siren is
communication device. It includes a receiver, to
receive event messages from the alarm system,
and a transmitter, to periodically transmit its status
signal to the alarm system.
D-302758
fully supervised, 2-way
Fig. 1a - External View
SR-730 PG2
Fig. 1b – Mounting
Position
39