Specifications - Visonic KF-234 PG2 Accessories Manual

Powermaster-10 accessories
Hide thumbs Also See for KF-234 PG2:
Table of Contents

Advertisement

SR-730 PG2
Self-test feature
Upon pressing the self test switch, siren functional check is performed - low level sounds and flash light indicate
that the siren is serviceable.

2. SPECIFICATIONS

Frequency Band (MHz)
Modulation
Antenna
Communication Protocol
Siren Type
Battery type
Battery Life Expectancy
Strobe Light
Operating Temperature
Dimensions (LxWxD):
Weight (including battery)
Color
Compliance with Standards
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
Interference Prevention
This device complies with FCC Rules Part 15. Operation is subject to two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference that may be received or that may
cause undesired operation.
The digital circuit of this device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in residential installations. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio and television reception. However, there is no guarantee that interference will not occur in a particular
40
Door or window
open/close detector
Wireless transmitter
Smoke detector
Motion detector
Figure 2- Typical Integration with the Alarm System
Europe: 433, 868, USA: 915
GFSK
Built-in antenna
PowerG
One Piezo 109 db min. Sound Pressure Level @ 1m, 1.4-3.2 kHz, sweep
frequency 7 Hz. Additional piezo is optional.
3.6V/14.5A/H Lithium battery (EVE ER34615M/w200), Visonic assembly
cat. No. 0-9912-K.
Note: The strobe flashes 5 times and the red LED lights continuously
during first battery installation.
Note: Use only the above battery.
Caution!
Risk of explosion if battery is replaced by an incorrect type. Dispose of
used battery according to manufacturer's instructions.
8 years (for typical use)
Pulsed @ 1 sec.
-33°C to 70°C (-27.4°F to 158°F), RH humidity 75%.
295x186x63mm (11-5/8 x 7-5/16 x 2-1/2 in)
970g (34 oz)
White (with red, blue, amber or transparent lens)
Europe: EN50131-1 Grade 2 Class 4, EN 50131-4, EN 301489, EN 50130-4,
EN 50130-5, EN 300 220, EN 60950-1, EN 60950-22
Environmental IP55.
USA: CFR47 Part 15
Canada: RSS 210
PowerMaster-10
SR-730 PG2
D-302758

Advertisement

Table of Contents
loading

Table of Contents