Table of Contents
Advertisement
CTR12000
2.2
Starting the welding machine
2.3
Operating mode "AUTO" (Running mode)
2.4
Operating mode "EDIT" (Modification mode)
2.5
Operating mode "Expert"
41644, EN - rev. 2, 2012-09
Attention: While on the screen „Synergic user programs", the machine al-
ways offers to the user the program X01 first. Save your newly written pro-
gram under another name (e.g. X02, X03 ... or J01, J02...) to prevent other
priory created programs from being overwritten.
The welding machine has been properly set up and connected to the mains.
Now switch on the machine using the main switch (see chapter 5: "Start-up"
in the first part of the operating manual).
After the machine has been switched on, it takes about 5 – 10 seconds until
the welding control system has performed a self-test. During this time, the
Car-O-Liner logo is displayed on the screen. After that, the selected synergic
welding program or the last program used is displayed on the screen.
The "AUTO" mode allows welding programs to be selected via synergic se-
lection parameters (welding process, task, selection, and tong).
This operating mode does not allow program modification but the selection
of invariable programs or, while in the ELMA-QS mode, to adapt the total
plate thickness and thus the synergic background parameters to the welding
task by means of the potentiometer "Power" I/kA. The plate thickness is ad-
justed independently of the potentiometer dial and is displayed in mm on the
large display screen.
For welding program modification, the key has to be put into the key lock
switch and turned to "EDIT". Only then you have access to variable parame-
ters that are explained in Optional settings, page 27.
This mode allows extended-range modification of the basic machine set-
tings. However, improper handling may impair welding results. Therefore
access is protected by a password.
Car-O-Liner Group AB
11
Hide quick links:
Advertisement
Table of Contents
