Table of Contents
Advertisement
Car-O-Liner Group AB
CTR12000
Furthermore you shall adjust the thickness of the OUTER SHEET to more
than 1 mm or less.
If you wish to return to the display screen, simply press the right soft key be-
low the field DISPLAY or activate this field by using the rotary encoder.
This screen allows you to adjust the total thickness of the plates to be welded
with the potentiometer "Power" l/kA to the desired value. The control sys-
tem computes the required welding current, energy and pressure in the back-
ground. The value set with the second potentiometer „Time" t/s is not con-
sidered with this procedure.
For positioning the welding tong on the work piece, the tong may be opened
and closed without current by pressing and releasing the start trigger up to
and from the first action point (please refer also to part 1 of the operating
manual "Setting up the welding machine"). After the welding tong has been
positioned, press the start button as far as it will go to start the welding pro-
cess.
Then the intelligent program ELMA-QS (while the tong being positioned
and closed) checks the initial welding conditions and takes into account par-
24
41644, EN - rev. 2, 2012-09
Hide quick links:
Advertisement
Table of Contents
