Usb- Device (11); Led Indicators (12-15) / Reset Button Q - Car-O-Liner CTR12000 Instruction Manual

CTR12000

1.1.6 USB- Device (11)

1.1.7 LED indicators (12-15) / Reset button Q

41644, EN - rev. 2, 2012-09
(8) QS-RED: Indicates that spot weld is faulty or not weldable, or faulty
current tong calibration or that the tong used is not suitable.
(9) QS-YELLOW: Indicates heating phase for preparing the spot weld or
warning limit for current tong calibration.
(10) QS-GREEN: Indicates that spot weld and/or current tong calibration
has been okay. Indicates alarm limit or current tong calibration error, if the
LED indicator QS-Yellow and/or QS-Red lights up, too.
QS-RED/YELLOW: Indicates that the spot weld is faulty, that there is a
problem of insulation, and that the welding operation has been interrupted
during the preheating phase.
The USB- Device offers most simple data transfer between operator and ma-
chine. The data is downloaded on or uploaded from a USB- Stick.
See chapter 3.8 "USB drive" for information on use.
Additional control elements are located on the lower control panel of the
power source.
NOTE! Also being incorporated in the handle of the welding tong.
12
13
Car-O-Liner Group AB
14
15
7