CTR12000
3.6.5 Editing synergy characteristics in the "VISION" mode
Definition of "welding power characteristics"
Entry of points for welding characteristics
Saving points
41644, EN - rev. 2, 2012-09
Optimising of parameters in the EDIT- mode the OPERATION MODE,
MANUAL should adjusted. It is recommended that no new Synergic param-
eters are set, because a correct adjustment between the %- parameters vab
and the value THICKNESS is required. Depending on the automatically
collected total thickness of the material, the database provides 35 physical
parameters for each welding process, which are controlled by the control
system Virtual Machine. The characteristic curves which are generated by
the virtual generator effect a drastic compensation of splatters, also with a
combination of long electrode arms, with a lower electrode force (<3,6 kN).
Same procedure as ELMA-QS, see chapter 3.6.4 (Entry of points).
Same procedure as ELMA-QS, see chapter 3.6.4 (Saving points).
Car-O-Liner Group AB
39