Table of Contents
Advertisement
Car-O-Liner Group AB
3.7
Options
3.7.1 General
40
In addition to the possibility of adapting existing programs to special cus-
tomer requirements and saving them as so-called X programs, the system of-
fers also the possibility to save selected working points of the synergistically
operating programs that are perfectly adapted to the corresponding welding
task as so-called "Jobs". These "jobs" are not running synergistically but are
in fact selected working points of a synergic program with an invariable set
of parameters.
For saving such jobs, select – while in the EDIT mode – the synergic weld-
ing program that suits the welding task (via synergic parameters) and deter-
mine in the individual case the welding energy required. After that, save this
"working point" as a job named from J01 to J99. If required, the welding pa-
rameters of a saved job can always be corrected in the EDIT mode and
"working points" can even be completely deleted or overwritten
Welding machines disposing of suitable optional interfaces can be used for
welding operation via remote control unit or with welding robots. If such an
automatic welding program is selected, the microprocessor control system of
the CTR12000 ensures that the welding operation is exactly performed with
"the selected working point" – i.e. with the optimum welding energy deter-
mined and the associated synergic parameters.
The job programs are activated in the AUTO mode via remote control or ro-
bot interface. Additionally, invariable synergic programs and X programs
may be selected via the remote control and robot interface. To this purpose,
the interface must be configured in the menu Machine configuration.
CTR12000
41644, EN - rev. 2, 2012-09
Hide quick links:
Advertisement
Table of Contents
