Car-O-Liner CTR12000 Instruction Manual page 33

CTR12000
41644, EN - rev. 2, 2012-09
Having selected OPEL VP (PSO Pre Spot Operation) the screen below ap-
pears:
After having switched to the DISPLAY mode, settings for welding operation
are made by adjusting the material thickness. Same procedure as with stand-
ard spot welding procedure ELMA-QS.
When the impurities is too thick, the welder will not allow welding.
For this reason it is recommended to use Pre Spot Operation (PSO).
This operation will eliminate all impurities such as ED coat, dirt, thin bond-
ing, thin rust etc.
The program to be selected for the different welding tasks is determined by
the automaker and given in his parameter documentation for car repair
zones.
Special service instructions issued by the automakers must be strictly
observed.
Car-O-Liner Group AB
33