Initial Start-Up; Switching On; Required Files; Figure 9: Main Menu - KEB COMBIVERT F6 Instructions For Use Manual

OPERATION OF THE OPERATOR

6.2 Initial start-up

6.2.1 Switching on

The operator is supplied by the drive converter. The operator switches on and off with
the drive converter. After switching on the operator searches automatically for the con-
nected drive converter, also in case of communication failure to the drive converter. The
actual checked node address is displayed on the bottom line in the start image and main
menu. This node number can also be read out in the operator parameter OS13.
When accessing via the Ethernet or USB interface, the used node address is optionally,
i.e. the operator responds to all node addresses.

6.2.2 Required files

The operator requires the following files in its flash memory for correct operation:
File Feature
language_f6.dat Contains the operator texts for the operator in all languages.
paras.blb Contains the parameter descriptions of all F6 operators as well as some F6 drive
converters.
xxxxx.blb Files to install additional drive converter types. Can be read out directly by some
drive converters.
Table 3: Operator files
The FTP mode (=>
files. Each file can be protected with an access level (=> File
Inverter parameter
Operator parameter
Parameter saving
Up/Download
Work list
File operations
FTP mode
Enter test mode
Figure 9: Main menu
and the PC program „KEB FTP" is used to install these
FTP mode)
The main menu is the uppermost menu level. With the keys ▲
and ▼ you can select the desired submenu.
Press ENTER to jump to the selected submenu.
Inverter parameter
operations).
19