Table of Contents
Advertisement
ECAT-2011H EtherCAT Slave I/O module
Step 2
Verify that the LEDs indicators on the ECAT-2011H module are
illuminated as illustrated below:
Once the power is connected, the "PWR" LED should be illuminated in red.
Once the Ethernet link is detected, the "IN" LED should be flash in green.
Once the ECAT-2011H connected to EtherCAT Master, the "RUN" LED should be illuminated in
red.
Red, OK
RUN
Green, OK
Figure 3-1.2
Copyright © 2018 ICP DAS CO., Ltd. All Rights Reserved.
- 14 -
Advertisement
Table of Contents
