Unexpected System Flow Change; Stuck Poppet; Rates Setup Tab; Preset Rate Values - Raven RCM-Sprayer Hawkeye 2 Calibration And Operation Manual

UNEXPECTED SYSTEM FLOW CHANGE

NOTE: This alarm is only available in Bypass and On/Off operation modes.
When enabled, the system change detection alarm allows the system to notify the operator if the calculated
system output flow is modified from learned values. Common situations that might cause this alarm to display are
if the tips have been changed recently on the system or if an unexpected leak or restriction has been introduced in
the system plumbing.

STUCK POPPET

NOTE: Not available in the Bypass or On/Off NCV2 operation modes. The stuck poppet alarm is a global
alarm option.
When enabled, the stuck poppet alarm option allows the system to notify the operator if an Hawkeye® 2 NCV on
the system does not detect movement of the poppet. The system will display an alarm and indicate which
Hawkeye® 2 NCV on the bus is encountering the condition.

RATES SETUP TAB

To access the Rates Setup tab:
UT Menu
1. Open the UT Menu and select the RCM - Sprayer Menu button.
2. Select the Tools Menu softkey along the right side of the display.
3. Select the Rates Setup tab along the top of the display.
4. The following options and features are available on the Rates Setup page:

PRESET RATE VALUES

Enter non-zero rate presets to allow the equipment operator to quickly switch between user defined rates during
field operations. While operating in the automatic product control mode, the rate preset buttons are displayed
within the product rate tab view on the Home page.
NOTE: In manual control mode, the rate preset buttons will be replaced with the control valve ± buttons.

PRESET PRESSURES

NOTE: Pressure presets are disabled in some nozzle control modes.
Enter non-zero pressure presets to allow the equipment operator to quickly switch between user defined
pressures during field operations. While operating in the automatic product control mode, the pressure preset
buttons are displayed within the pressures tab view on the Home page.
NOTE: In manual control mode, the pressure preset will be replaced with the NCV2 PWM percent ± buttons.
System Setup: Rates Setup Tab
RCM - Sprayer Menu Tools Menu Rates Setup
SYSTEM SETUP
37