Chapter 6 Operation; Operation Checklist - Raven RCM-Sprayer Hawkeye 2 Calibration And Operation Manual

CHAPTER
6

OPERATION CHECKLIST

To begin applying product using the Rate Control Module (RCM) - Sprayer control system:
1. Verify the proper control mode (Standard, Bypass, On/Off, High Flow, or VP) is enabled.
2. Verify the tip size selection for the nozzle control system.
3. Verify the product type (Water-Based or Fertilizer). Refer to the Product Type section on page 28.
4. Set the desired target rate and pressure. Refer to the Status and Control Inputs section on page 46 for
additional information.
NOTE: Target pressure is not available when operating in the VP, ON/OFF, or Bypass modes.
5. If the machine is equipped with a master tank valve, verify the tank valve is open to direct flow to the carrier
pump.
6. If the machine is equipped with a toggle switch to engage the pump, it may be necessary to engage the switch
before using the Engage Pump softkey on the RCM - Sprayer screen.
7. Select the product pump softkey to toggle the product pump on. Refer to the (4) Main Product section on
page 47 for additional information.
8. Toggle the equipment master switch to the on position.
Operation: Operation Checklist
O PERATION
C H A P T E R 6
43