Raven RCM-Sprayer Hawkeye 2 Calibration And Operation Manual page 50

C 5
HAPTER
FIGURE 1. Setup Product Delay
6. Press Next. The Section Offsets page is displayed.
FIGURE 2. Section Offsets
Self-Propelled
Sprayer
7. Enable the Left of Center option if the boom is offset to the left of the centerline of the sprayer. If the boom is
centered on the sprayer or is offset to the right, leave the Left of Center option unchecked.
8. Measure the distance from the center of the boom to the centerline of the sprayer. Enter the measurement in
the A field in inches [centimeters].
NOTE: The value entered for the A distance must be measured perpendicular to the direction of vehicle
travel.
9. Enable the Rear Implement option if the boom is mounted over or behind the rear axle of the machine or the
pivot point of a pull-type sprayer. If the boom is mounted at the front of the sprayer, or in front of the rear axle,
leave the Rear Implement option unchecked.
40 RCM - Sprayer and Hawkeye® 2 Calibration and Operation Manual
Pull-Type
Sprayer