Chapter 2 Introduction - Raven RCM-Sprayer Hawkeye 2 Calibration And Operation Manual

CHAPTER
2
The Raven Rate Control Module (RCM) - Sprayer system is designed to provide multi-product rate control via an
ISOBUS universal terminal (UT).
Adding the Hawkeye® 2 nozzle control system to the RCM - Sprayer allows the machine operator to monitor and
control pressure independently from the application rate without additional displays, controllers, or consoles.
This document provides information regarding the following aspects of the RCM - Sprayer and Hawkeye® 2
control systems:
• Initial Setup and Navigation
• Calibration
• System Operation
• Updating Components
NOTE: Prior to using the control features with any UT display, the
Control Unit (ECU) must be calibrated for the control system. Refer to Chapter 3, System Calibration,
for assistance with completing the initial calibration wizard.
This manual assumes that the required control hardware is already installed on supported equipment
and is properly connected. Refer to the Updates section on page 9 for installation manual resources or
contact a local Raven dealer for additional information on supported equipment configurations.
Introduction:
I NTRODUCTION
C H A P T E R 2
RCM - Sprayer and Hawkeye® 2 Electronic
5