Diagnostic Trouble Code (Dtc) List - Raven RCM-Sprayer Hawkeye 2 Calibration And Operation Manual

CHAPTER 9
6. Use a small jumper wire (e.g. paper clip) to short the ground and signal sockets with a "short-no short" motion.
Each time the short is made, the total volume value should change by increments of one or more.
7. If the Flow Meter (Hz) value stays at zero, disconnect this section of flow meter extension cable and repeat this
test at the next connector closest to RCM - Sprayer ECU. Replace defective cable as required.
8. If all cables test good, replace the flow meter.
9. After testing is complete, re-enter correct meter cal value and units.

DIAGNOSTIC TROUBLE CODE (DTC) LIST

The following trouble codes may be displayed by the control system and should help the operator to identify and
correct issues with system during field operations:
Code ID
10 .13
158 .1
168 .1
.13
630
.31
.2
1563
.17
.31
62
Description
UT display is not on-line
Logic SW power error
Battery voltage error
System calibration required
NCV2 Calibration Error
Nozzle control valves
incompatible with RCM -
Sprayer ECU
NCV2 programming out of
date
Inconsistent nozzle control
valve software version
RCM - Sprayer and Hawkeye® 2 Calibration and Operation Manual
Recommended Actions
1. If this error occurs frequently, check the
ISOBUS connections and review the UT
display troubleshooting procedures.
2. Connect the Raven Service Tool to the
ISOBUS and verify communication.
1. Verify logic voltage is at or above 4.8 V to
RCM - Sprayer ECU.
1. Verify HC voltage to RCM - Sprayer ECU is
above 9 V.
1. Complete the calibration wizard to configure
all required RCM - Sprayer system settings.
Refer to Chapter 3, System Calibration for
additional assistance with the calibration
wizard.
1. Complete the calibration wizard to configure
all required RCM - Sprayer system settings.
Refer to Chapter 3, System Calibration for
additional assistance with the calibration
wizard.
2. Cycle system power.
3. Edit profile.
1. Check for RCM - Sprayer ECU software
updates.
2. Check for nozzle control valve software
updates.
3. Cycle system power.
4. Edit profile.
1. Check for nozzle control valve software
version differences. Update the nozzle control
valves to a consistent software version.
1. Check for nozzle control valve software
version differences. Update the nozzle control
valves to a consistent software version.