Configuration Using Barcodes; Suffix (Header /Terminator ) - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3

Configuration Using Barcodes

3.6.1 Global Prefix/
Suffix (Header/
Terminator)
58
This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF. The characters may be added as a prefix (in a position before the barcode data, also
called a header) and/or as a suffix (in a position following the barcode data, also called a termina-
tor). See page 252 for more detailed instructions on setting this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above to place
the unit in Programming Mode, then the "Set Global Prefix" or "Set Global Suffix," barcode fol-
lowed by the digits (in hex) from the Alphanumeric characters in
ing your desired character(s). If less than the expected string of 20 characters are selected, scan
the ENTER/EXIT barcode to terminate the string. Exit programming mode by reading the ENTER/
EXIT barcode again.
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
DEFAULT
Appendix D: Keypad
$CLFPR
Set Global Prefix
~
CANCEL
No Global Prefix
Global Suffix = 0x0D (CR)
represent-