Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3
Configuration Using Barcodes
Bluetooth
Friendly Name
Bluetooth
Reconnect
Attempt Mode
232
You can set a meaningful name for BVS HS-PB that will appear in the application during device
discovery.
To set a new Bluetooth Friendly Name, scan the barcode below and follow the instructions.
$CBTFN
Set Bluetooth Friendly Name
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
DEFAULT
Enable/Disable reconnection by trigger pull.
$CBTRM01
Bluetooth Reconnect Attempt Mode =
Enable
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by a
maximum 64 digits from the Alphanumeric
Appendix D: Keypad
characters in
its must be the hexadecimal ASCII represen-
tation of the desired characters. If less than
the expected string of 32 characters are
selected, scan the ENTER/EXIT barcode to
terminate the string.
~
CANCEL
BVS HS-PB
[SERIAL_NUMBER_READER]
$CBTRM00(C
Bluetooth Reconnect Attempt Mode =
Disable
DEFAULT
. The dig-