Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
4
References
4.2.3 Intercode Delay
Wedge
Intercode Delay
Examples
248
Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1 Determine the desired setting.
2 Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
etc
3 Go to
page 50
and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4 Scan the barcode: SELECT INTERCODE DELAY SETTING.
5 Scan the appropriate two digits from the keypad in
duration which was determined in the steps above. You will hear a two-beep indication after
the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See
of how to set this feature.
STEP ACTION
1
Desired Setting
Pad with leading
2
zero(es)
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT INTERCODE DELAY SETTING
Scan Two Characters
5
From
Appendix D:
Keypad
6
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D:
Table Wedge Intercode Delay Examples
EXAMPLES
No Delay
5 Seconds
00
05
'0' and '0'
'0' and '5'
Keypad, that represent the
for some examples
60 Seconds
99 Seconds
60
99
'6' and '0'
'9' AND '9'