Stand Mode Off Time - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
4
References
4.6.2 Stand Mode Off
Time
Stand Mode Off
Time
262
This feature specifies the amount of time reader illumination stays off after pulling the trigger when
in Stand Mode. The configurable range is 01 to 32 by 01 in increments of 500ms (500ms to 16
seconds).
Follow these instructions to set this feature:
1 Determine the desired setting.
2 Pad the result with leading zeroes to yield two digits. For example: 2 = 02, 5 = 05, 20 = 20,
etc.
3 Go to page 79 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4 Scan the barcode: Set Stand Mode Illuminator Off Time.
5 Scan the appropriate two digits from the keypad in
setting which was determined in the steps above. You will hear a two-beep indication after the
last character.
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See
this feature.
STEP ACTION
1 Desired Setting
2 Pad leading zero
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT STAND MODE OFF TIME
Scan Two Characters
5 From Appendix D:
Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Appendix D:
Table Stand Mode Off Time for some examples of how to set
EXAMPLES
500 ms 1 Second 5.5 Seconds
01 02
'0' and '1' '0' and '2'
Keypad, that represent the
16 Seconds
11 32
'1' and '1' '3' and '2'