Flash Off Time - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
4
References

4.6.6 Flash Off Time

Flash Off Time
Setting
Examples
266
This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments.
Follow these instructions to set this feature.
1 Determine the desired setting in milliseconds.
2 Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3 Go to page 81 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4 Scan the barcode: SELECT FLASH OFF TIME SETTING.
5 Scan the appropriate two digits from the keypad in
duration which was determined in the steps above. You will hear a two-beep indication after
the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See
how to set this feature.
STEP ACTION
1 Desired Setting
Divide by 100 (and pad
2 with leading zeroes to
yield two digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT FLASH OFF TIME SETTING
Scan Two Characters
5 From Appendix D:
Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Appendix D:
Table Flash Off Time Setting Examples
EXAMPLES
1,000ms
500ms
(1 sec.)
05 10
'0' and '5' '1' and '0'
Keypad, that represent the
for some examples of
5200ms 9,900ms
(5.2 sec.) (9.9 sec.)
52 99
'5' and '2' '9' and '9'