Scan Mode - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
4
References
4.6 Reading
Features

4.6.1 Scan Mode

www.balluff.com
This mode is associated with typical handheld reader operation. Selects the scan operating mode
for the reader. The following selections are valid for all models:
Trigger Single: When the trigger is pulled, reading is activated until one of the following occurs:
- Reading Active Time has elapsed
- a label has been read
- the trigger is released
Trigger Hold Multiple: When the trigger is pulled, reading starts and the product scans until the
trigger is released or Reading Active Time
Double Read Timeout prevents undesired multiple reads of the same label while in this mode.
Trigger Pulse Multiple: When the trigger is pulled, continuous reading is activated until
Active Time has elapsed or the trigger has been released and pulled again.
prevents undesired multiple reads of the same label while in this mode.
Flashing: The reader flashes on and off regardless of the trigger status. Flash rate is controlled by
Flash On Time Flash Off Time
and
Flash is OFF reading is deactivated.
Always On: No trigger pull is required to read a barcode. reading is continually on. If the trigger is
pulled, the reader acts as if it is in Trigger Single Mode.
multiple reads of the same label while in this mode.
Stand Mode: No trigger pull is required to read a barcode. Reading is turned on automatically
when an item is placed in the reader's field of view.
multiple reads while in this mode.
has elapsed. Reading a label does not disable reading.
. When Flash is ON the imager reads continuously; when
Double Read Timeout
Double Read Timeout
Reading
Double Read Timeout
prevents undesired
prevents undesired
261