Intercharacter Delay - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
4
References
4.2.2 Intercharacter
Delay
Intercharacter
Delay Setting
Examples
www.balluff.com
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in 10ms
increments. A setting of zero specifies no delay.
This feature applies ONLY to the Keyboard Wedge interface.
NOTE
To set the delay:
1 Determine the desired setting in milliseconds.
2 Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3 Go to page 38 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4 Scan the barcode: SELECT INTERCHARACTER DELAY SETTING.
5 Scan the appropriate two digits from the keypad in
duration which was determined in the steps above. You will hear a two-beep indication after
the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See
ples of how to set this feature.
STEP ACTION
1 Desired Setting
Divide by 10 (and pad
2 with leading zeroes to
yield two-digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCHARACTER DELAY SETTING
Scan Two Characters
5 From Appendix D:
Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Appendix D:
Table Intercharacter Delay Setting Examples
EXAMPLES
50ms 150ms
05 15
'0' and '5' '1' and '5'
Keypad, that represent the
for some exam-
600ms 850ms
60 85
'6' and '0' '8' and '5'
247