Date-Time Separator - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3
Configuration Using Barcodes
Date-Time
Separator
222
Sets the character used to separate Date and Time from the next field in message.
DEFAULT
$CRFTD01\r
Set Character Separator =
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
$CRFTD0000\r
Disable Date-Time Separator
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by 2
digits from the Alphanumeric characters in
Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
~
CANCEL