Reading Active Time - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
4
References
4.6.3 Reading Active
Time
Reading Active
Time Setting
Examples
www.balluff.com
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments.
Follow these instructions to set this feature:
1 Determine the desired setting.
2 Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 =
020, etc.
3 Go to page 80 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4 Scan the barcode: SELECT READING ACTIVE TIME SETTING.
5 Scan the appropriate three digits from the keypad in
duration which was determined in the steps above. You will hear a two-beep indication after
the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See
ples of how to set this feature.
STEP ACTION
1 Desired Setting
2 Pad leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT READING ACTIVE TIME SETTING
Scan Three
5 Characters From
Appendix D: Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Appendix D:
Table Reading Active Time Setting Examples
EXAMPLES
90 Sec.
1 Second
(1.5 min.)
001 090
'0', '0' and '0', '9' and
'1' '0'
Keypad, that represent the
for some exam-
180 Sec. 255 Seconds
(3 min.) (4.25 min.)
180 255
'1', '8' and
'2', '5' and '5'
'0'
263