Disable Character On Page; Enable Character On Page - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3
Configuration Using Barcodes
Disable
Character
Enable
Character
$CR2EC
www.balluff.com
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands
conflicts with normal operation of these characters. 8-bit data is not recognized
when the option
NOTE
See page 244 for more information on setting this feature.
$CR2DC
Select Disable Character Setting
DEFAULT
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands
conflicts with normal operation of these characters. 8-bit data is not recognized
when the option
NOTE
See page 245 in "References" for more information on setting this feature.
Select Enable Character Setting
DEFAULT
Data Bits has been set as 7 Data Bits.
0x44 = Disable Character is 'D'
Data Bits has been set as 7 Data Bits.
0x45 = Enable Character is 'E'
43