Batch Features; Batch Mode; Send Batch - Balluff BVS HS-P Series Operation Manual

Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3
Configuration Using Barcodes

3.11.3 Batch Features

Batch Mode

Send Batch

www.balluff.com
This option specifies whether to store labels in the handheld while disconnected from the base.
Options are as follows:
- Disabled — The handheld will not store/batch labels.
- Automatic — The handheld will store labels to RAM when the handheld goes out of range and
is disconnected from the remote device.
- Manual — The handheld will always store labels to Flash memory. The user must manually
send the stored labels to the remote device using a special "batch send" label.
DEFAULT
$CBTBM01(C
Batch Mode = Automatic
When the reader is configured in Manual Batch Mode, use the following barcode to initiate send-
ing of labels stored in batch memory.
Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunction
with this barcode.
NOTE
BatchSend
$CBTBM00(C
Batch Mode = Disabled
$CBTBM02(C
Batch Mode = Manual
Send Batch
215