It lights up yellow
The AdBlue reserve is low.
Refill AdBlue within the next kilometres (or miles) that
›››
are indicated
page
308. SEAT recommends con-
tacting a specialised workshop.
They light up yellow
and
There is a fault in the AdBlue system or unsuitable
AdBlue fluid has been used.
Contact a specialised workshop. Have the system
checked there.
Several warning and control lamps should
light up for a few seconds when the ignition is
switched on, signalling that the function is be-
ing verified. They will switch off after a few
seconds.
WARNING
Observe the safety warnings
trol and warning lamps on page
308
Fill AdBlue®
AdBlue tank cap.
Fig. 218
Operations prior to refilling
Park the vehicle on a flat surface and turn off
the ignition. If the vehicle is on a slope or on a
curb, the level indicator may not detect the
refill properly.
If an AdBlue® warning message is shown on
›››
in Con-
the instrument cluster display, fill with at
90.
least the minimum required amount (ap-
prox. 5 litres). Only after adding this amount
will the system detect that AdBlue® has been
added and you will be able to start the en-
gine again. The maximum amount that can
be refilled is 11 litres.
Fill with a refill bottle
Only use AdBlue® that complies with the
ISO 22241-1 standard. Only use original
containers.
Practical tips
›››
Open the tank cover
Fig.
218.
●
Unscrew the tank cap by turning it in an an-
●
ti-clockwise direction.
Please observe the manufacturer's instruc-
●
tions, indicated on the refill bottle.
Check the expiry date.
●
Remove the cap of the refill bottle.
●
Insert the neck of the bottle in the tank filler
●
neck vertically and screw the bottle on by
hand, by turning it in a clockwise direction.
Press the refill bottle in the direction of the
●
filler neck and hold it in this position.
Wait until the contents of the refill bottle
●
have been poured into the AdBlue® tank. Do
not compress or break the bottle!
Turn the bottle in a counter-clockwise di-
●
rection and gently pull it upwards
The AdBlue® tank is full when no more liq-
●
uid comes out of the bottle.
Screw on the tank cap in a clockwise direc-
●
tion until it is tightly closed.
Close the fuel tank flap.
●
Operations before driving
After refilling the tank, only switch on the ig-
●
nition.
Leave the ignition on for at least 30 sec-
●
onds for the system to detect the fluid load.
Make sure you wait for at least 30 seconds
●
before starting the engine!
›››
.