Delete Journey Data Presets; Select The Instructions; Warning And Information Messages; Display Oil Temperature - Seat Ateca 2020 Owner's Manual

exceeded (varies depending on the ver-
sion of the instrument panel), the memo-
ry is deleted.

Delete journey data presets

Select the memory that you wish to erase.
●
Hold the button of the multifunction
● 
steering wheel or the button of the multi-

function wheel pressed down for about 2
seconds.

Select the instructions

In the Infotainment system, in the menu Vehi-
cle settings, you can display different travel
›››
data page 95.
– The current
Current consumption:
fuel consumption display operates
throughout the journey, in litres/100 km;
and with the engine running and the ve-
hicle stopped, in litres/hour.
– The average
Average consumption:
fuel consumption is displayed after driv-
ing for approximately 300 metres.
– This indicates the
Travelling time:
hours (h) and minutes (min) since the ig-
nition was switched on.
– Approximate distance in km that
Range:
can still be travelled if the same driving
style is maintained.
1) Not available in all countries.
Instruments and warning/control lamps
– Approximate
AdBlue range or :

distance in km that can still be travelled
with the current level of the AdBlue®
tank with the same driving style. The in-
dication appears from a range of less
than 2,400 km and cannot be deactiva-
1)
ted.
– Distance covered in km (m)
Distance:
after switching on the ignition.
– The average speed
Average speed:
will be shown after driving for approxi-
mately 100 metres.
–
Digital speed display:
speed displayed in digital format.
Setting a speed warning
Select the display Warning at --- km/h
●
or Speed warning at --- mph .
Press the button on the windscreen
●

wiper lever or the button on the multifunc-

tion steering wheel to store the current speed
and activate the warning.
Activate: adjust to the desired speed within
●
5 seconds using the rocker switch
windscreen wiper lever or by turning the
thumbwheel on the multifunction steering
wheel. Next, press the button
again or wait several seconds. The speed is
stored and the warning activated.
Deactivate: press button
●
. The stored speed is deleted.

The warning can be adjusted for speeds be-
tween 30 km/h (18 mph) and 250 km/h
(155 mph).

Display Oil temperature

The engine reaches its operating tempera-
ture when, under normal driving conditions,
the oil temperature is between 80°C (176°F)
and 120°C (248°F). If a great effort is required
from the engine and the outside temperature
Current
is high, the engine oil temperature may in-
crease. This does not present any problem as
long as the warning lamps
›››
page 315

Warning and information messages

(Vehicle status)
The system runs a check on certain compo-
nents and functions when the ignition is
switched on and while the vehicle is moving.
on the

Faults are displayed on the instrument cluster
display as red and yellow warning symbols
accompanied by messages and, depending
or
 
on the case, even an audible warning
or button

or
 
do not appear on the display.
»
77