Operating The Speed Limiter With The Turn Signal Lever - Seat Ateca 2020 Owner's Manual

value, the limiter switches on again. The con-
trol lamp lights up and remains lit.

Automatic off
The speed limiter is automatically switched
off:
If the system detects a fault that could neg-
●
atively affect the working order of the limiter.
If the airbag is triggered.
●
WARNING
After use, switch off the speed limiter to
prevent the speed being regulated without
it being required.
The speed limiter does not relieve the
●
driver of their responsibility to drive at the
appropriate speed. Do not drive at high
speed if not necessary.
Using the speed limiter in adverse weath-
●
er conditions is dangerous and can cause
serious accidents. Use the speed limiter
only when the condition of the road surface
and the weather and traffic conditions al-
low it.
When driving on a steep gradient, the
●
speed limiter cannot limit the vehicle's
speed. This can increase. In this case, brake
and change down a gear.
Driver assistance systems
CAUTION
For automatic switching off due to system
failures, for security reasons, the limiter is
only completely switched off when the
driver stops pressing the accelerator or
consciously switches it off.
Note
Different versions of the instrument panel
●
are available and therefore the versions
and instructions on the display may vary.
If the cruise control (GRA), the adaptive
●
cruise control (ACC) or the speed limiter
are connected when the ignition is switch-
ed off, the assistants will switch it when the
ignition is switched on, but only the speed
limiter will maintain the last programmed
speed.
Operating the speed limiter with
the turn signal lever
On the turn signal lever: buttons to
Fig. 176
operate the speed limiter.
Connecting
›››
Move control Fig. 176 to position
●
1
and press button .
2
The last programmed speed is stored. It does
not take effect yet.
Activating the speed limiter
›››
While driving, press button
●
the area .

The current speed is stored as the maximum
speed.
Setting the programmed speed
You can set the speed using button
›››
Fig. 176 :
3

Fig. 176 in
3
»
243