Headlight Switch; Daytime Running Lights; Motorway Light; Automatic Dipped Beam Headlight Control - Seat Ateca 2020 Owner's Manual

Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
WARNING
Observe the safety warnings
trol and warning lamps on page

Headlight switch

Dash panel: lights control.
Fig. 107
Turn the switch to the required position
●
›››
Fig. 107.
Sym- Ignition switch-
bol ed off
Fog lights, dipped

beam and side
lights off.
120
Sym- Ignition switch-
bol ed off
The "Coming
home", "Leaving

home" and Wel-
come lights may be
switched on.
›››
in Con-

90. Side light on.
Dipped beam head-

light off
The driver is personally responsible for the
correct use and adjustment of the lights in all
situations.

Automatic dipped beam headlight control

*

The automatic dipped beam control is merely
intended as an aid and is not able to recog-
nise all driving situations.
When the light switch is in position
vehicle lights and the instrument panel and
switch lighting switch on automatically in the
following situations
The photo sensor detects darkness, for ex-
●
ample, when driving through a tunnel. They
Ignition is
switch off when adequate lighting is detec-
switched on
ted.
Daylight running
lights switched on.
Operation
Ignition is
switched on
Automatic control
of dipped beam
and daytime run-
ning light.
Daylight running
lights switched on.
Dipped beam
switched on.
, the

›››
:
The rain sensor detects rain and activates
●
the wipers. They switch off when the wipers
have not been activated for a few minutes.

Daytime running lights

The daytime running lights consist of individu-
al lights, integrated in the front headlights.
These lights come on when the daytime run-
ning lights are switched on. On vehicles
equipped with LED tail lights, the rear side
›››
light is switched on as well
The daytime running lights turn on every time
the ignition is switched on, if the switch is in
position or , according to the level of ex-
 
terior lighting.
When the light switch is in position
sensor automatically switches dipped beam
on and off (including the control and instru-
ment lighting) or the daytime running lights
depending on the level of exterior lighting.

Motorway light*

The motorway light is available on vehicles
equipped with full-LED lights.
The function is connected and disconnected
via the corresponding Infotainment system
menu.
Activation: when going above 110 km/h
●
(68 mph) for more than 10 seconds, the dip-
ped beam raises slightly to increase the driv-
er's visibility distance.
.
, a light
