Unlocking And Locking The Boot Hatch; Automatically Disabling Sensors; Convenience Functions; Keyless Access Temporary Disconnection - Seat Ateca 2020 Owner's Manual

In vehicles with the "Safe" security sys-
tem: closing and locking the doors
(Keyless-Exit)
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the sensor surface
●
(arrow) on one of the front door handles.
B
The vehicle locks with the "Safe" security sys-
›››
tem page 105. The door that is used must
be closed.
Touch (twice) the sensor surface
●
(arrow) of one of the front door handles to
B
lock the vehicle without activating the
"Safelock" security system

Unlocking and locking the boot hatch

When the vehicle is locked, the rear lid auto-
matically unlocks on opening if there is a val-
id vehicle key in the proximity zone
Open or close the rear lid normally.
After closing, the hatch locks automatically. If
the complete vehicle is unlocked, the rear lid
will not lock automatically after closing it.
What happens when locking the vehicle
with a second key
If there is a vehicle key inside the vehicle and
it is locked from the outside with a second ve-
hicle key, the key inside the vehicle is blocked
›››
for engine ignition page
104
enable engine ignition, press the
the key inside the vehicle.

Automatically disabling sensors

If the vehicle is not locked or unlocked for a
long period of time, the proximity sensors on
›››
Fig. 92
the passenger doors are automatically disa-
bled.
If one of the sensor surfaces on the door han-
dles is often activated in an unusual manner
with the vehicle locked (e.g. by the branches
›››
Fig. 92
of a bush rubbing against it), all proximity
sensors are disabled for a certain period of
time.
›››
page 105.
Sensors will again be enabled:
After a time.
●
OR: if the vehicle is unlocked with the but-
●
ton on the key.

›››
Fig. 91.
OR: if the boot is opened.
●
OR: if the vehicle is unlocked manually with
●
the key.

Keyless Access temporary disconnection

function*
You can deactivate the vehicle's Keyless
Access unlocking for one locking and unlock-
ing cycle.
Move the gear lever to position P (if the ve-
●
212. In order to
hicle has automatic gearbox), since other-
wise the vehicle cannot be locked.
Operation
button on

Close the door.
●
Push the central locking button
●
mote control and touch the locking sensor
surface of the driver door handle
›››
Fig. 92 within the following 5 seconds.
B
Do not grasp the door handle; otherwise the
vehicle will not unlock. Deactivation is also
possible if the vehicle is locked through the
driver's door lock.
To check that the function has been deacti-
●
vated, wait at least 10 seconds, grip and pull
on the door handle. The door should not
open.
The next time the door can only be unlocked
via the remote control or the lock cylinder.
The next time the door is locked/unlocked,
Keyless Access will be active again.

Convenience functions

To close all the electric windows and the sun-
roof using the comfort function, keep a fin-
ger for a few seconds on the locking sensor
›››
surface Fig. 92 (arrow) of the door han-
B
dle until the windows and roof have closed.
How the doors open when touching the sen-
sor surface on the door handle will depend
on the settings that have been activated in
the infotainment system, using the function
button  > SETTINGS > Opening and
.
closing
on the re-
