Jump Start; Jump Leads; Cleaning Windscreen Wiper Blades - Seat Ateca 2020 Owner's Manual

Raising and lowering windscreen wiper
arms
Place the windscreen wipers in the service
●
›››
position page 49.
Grip the wiper arms only by the blade's
●
fastening point.

Cleaning windscreen wiper blades

Raise the wiper arms.
●
Use a soft cloth to remove dust and dirt
●
from the windscreen wiper blades.
If the blades are very dirty, a sponge or
●
damp cloth may be used
Changing the windscreen wiper blades
Lift and unfold the wiper arms.
●
Press and hold release button
●
and pull gently on the wiper blade in the di-
rection of the arrow.
Fit a new wiper blade of the same length
●
and design on to the wiper arm and hook it
into place.
Rest the wiper arms back onto the wind-
●
screen.
Changing the rear window wiper blade
Lift and fold the wiper arm.
●
›››
Turn the blade slightly
●
50
Hold down the release button
●
tly pulling the blade in the direction of arrow
.
B
Insert a new blade of the same length and
●
type in the rear wiper arm in the opposite di-
rection to the arrow
button
Replace the wiper arm on the rear window.
●
WARNING
Worn or dirty windscreen wiper blades re-
duce visibility and increase the risk of acci-
dent and serious injury.
›››
.
Always replace damaged or worn wind-
●
screen wiper blades or blades that no lon-
ger clean the windscreen properly.
››› CAUTION
Fig. 41
1
Damaged or dirty windscreen wipers
●
could scratch the glass.
If products containing solvents, rough
●
sponges or sharp objects are used to clean
the blades, the graphite layer will be dam-
aged.
Never use fuel, nail varnish remover, paint
●
thinner or similar products to clean the win-
dows.
In icy conditions, always check that the
●
wiper blades are not frozen to the glass be-
Fig. 42 (arrow ).
A
fore using the wipers. In cold weather, it
may help to leave the vehicle parked with
the wipers in service position
Emergencies
while gen-
1
and hook into place
B
.
1
›››
page 49.
CAUTION
To prevent damage to the bonnet and the
●
wiper arms, only leave them in the service
position.
Before driving, always lower the wiper
●
arms.

Jump start

Jump leads

The jump lead must have a sufficient wire
cross section.
If the engine fails to start because of a dis-
charged battery, the battery can be connec-
ted to the battery of another vehicle to start
the engine.
Jump leads must comply with standard DIN
72553 (see cable manufacturer's instruc-
tions). The wire cross section must be at least
2
25 mm for petrol engines and at least
35 mm 2 for diesel engines.
Note
The vehicles must not touch each other,
●
otherwise electricity could flow as soon as
the positive terminals are connected.
The discharged battery must be properly
●
connected to the on-board network.